Rack & Platform Systems

Bullard Companydesigns, engineers, and fabricates rack systems to fit your loading, unloading, inspection, and sampling applications.  Our rack systems provide your operators not only a design that makes loading and unloading operation as convenient, safe, and durable as possible, it adds to the overall efficiency of the operation. 

Designing and fabricating rack systems is just one of Bullard Company's strengths.  Fabricating them to the last is the easy part - Bullard takes a proactive approach to making sure that the structure meets all the applicable local, state, and federal codes as outlined by OSHA.  Fall prevention is continually looked at to make sure the handrails, toe plates and grab rails not only meet these guidelines but consider your operator's safety.

Safety being the main concern, operator mobility is the second most important considerations.  Work area and operator mobility shoule be unobstructed. Canopy heights provide ample clearance for loading/unloading arm positioning.

Bullard has four basic designs:

• Half Canopies: Protects the operation on one side of the platform
• Full Canopies:Protects the operations on both sides of the platform
• Racks without Canopies in a cingle center column
• Racks without Canopies with a multi-column design

All of our rack systems can be equipped with the safety bridges or stairs, complete safety systems or enclosures for access to the entire truck top.

 

In addition to the various  designs, our rack systems can include optional or non-standard equipment additions or features.  Bullard Company has taken the design of rack systems to a new level.  Given the application, our racks can be designed in modular sections that can be pre-piped, ready for installation.

Modular rack systems allow minimal site disruption, and limited onsite personnel which translates into limted exposure to accidents or lost time.  Modular rack systems allow you to bring your operations online quicker than assembling the rack system in the fields with the piping cut and welded in site under uncontrollable conditions.  

• Fabrication:All rack systems are fabricated and pre-assembled by certified welders.  Each weld is certified to the America Welders Society codes.
• Durability: All rack systems are designed to the environmental conditions for each job site to allow for the proper material strengths.
• Finishes and Coatings: Each rack system is available in a variety of finishes.  Hot dip galvanized is the most durable.  Red oxide primer and an epoxy two-part pain finish is also available.
• Cost Effective:Our rack systems are fabricated in wither modular sections already pre-piped or in the largest shippable fabricated section to facilitate reduced set-up times.  Smaller platforms can be shipped to the job site completely assembled.

Whatever your needs may be, let Bullard Company provide the soluation for your project.